3D Systems CUBE Quick Start Manual page 27

3rd generation

Hide thumbs Also See for CUBE:

Table of Contents

Clean The Print Pad

Remove the print pad from the printer.

Wash all glue and print material from the print pad with warm tap water. If necessary, scrub the

print pad with a soft brush.

Dry the print pad thoroughly.

If residual print material is still adhered to the print pad, gently use the scraper to remove it. Refer

to the User Guide for more information.

Using the included fine-grit sandpaper, lightly sand the print pad left-to-right in .5" (12.7 mm)

swirling motions until the entire print pad has been treated.

NOTE: It is most important to gently sand all shiny parts of the print pad so the print

pad surface appears matte in texture.

Clean and dry the print pad thoroughly.

Perform Auto Level and Auto Gap procedures.

Table of Contents