Connecting To Dc Power Source - KTI Networks KGS-2800 Installation Manual

CONNECTING
TO DC POWER
SOURCE
Figure 13: Inserting the DC Power cable to DC terminal block to power on this
switch
Step1.
Insert the DC cable plug directly into the DC terminal block located at the front
of the switch.
Step2.
Plug the other end of the cable into an external DC power source.
Step3.
Check the front-panel LEDs as the device is powered on to be sure the POWER
LED is lit. If not, check that the power cable is correctly plugged in.
You can plug or remove DC power cable through the DC terminal
block from external 48VDC DC power source.
13