Table of Contents
Advertisement
DESKTOP OR SHELF MOUNTING:
Step1.
Attach the four adhesive rubber feet to the bottom of the first switch.
Figure 11: Attaching the Adhesive Rubber Feet
Step2.
Set the device on a flat surface near an AC power source, making sure there are
at least two inches of space on all sides for proper air flow.
Step3.
If installing a single switch only, go to "Connecting to a Power Source" at the end
of this Chapter.
Step4.
If installing multiple switches, attach four adhesive feet to each one. Place each
device squarely on top of the one below, in any order.
INSTALLING AN
OPTIONAL SFP
TRANSCEIVER
You can install or remove a mini-GBIC SFP from a mini-GBIC slot
without having to power off the switch. Use only Manufacture
mini-GBIC.
N
:
OTE
The mini-GBIC slots are shared with the two 10/ 100/
1000Base-T RJ-45 ports. If a mini-GBIC is installed in a
slot, the associated RJ-45 port is disabled and cannot be
used
The mini-GBIC ports operate only at full duplex. Half
duplex operation is not supported.
Ensure the network cable is NOT connected when you
install or remove a mini-GBIC.
Use only supported genuine Manufacture mini-GBICs
C
:
AUTION
with your switch. Non-Manufacture mini-GBIC might have
compatible issue, and their use may result in product malfunction.
10
Advertisement
Table of Contents
