Barco E2 User Manual page 98

6. GUI orientation
Image 6-25
Since the software assigns automatically only 2K outputs, Dual link or 4K outputs need to be configured manually. See How to add
output section below.
Next to the configuration name is the name of the Destination where the output is assigned. If the Output is not assigned to any
Destination, then the name will be "N/A"
The software by default names outputs as "Output 1, 2, 3..." The user can rename each output by double-
clicking on the name and type in the new name in the blue box.
How to add Output
Outputs configurations can be added manually to un-assigned connectors.
1. Click on the Add Output button.
The Add Output button is replaced by the Done Adding button (highlighted in blue).
2. In the System diagram area, click on the connector(s) that need to be assigned.
Note: If the output is 4K provided by the 4 SDI connectors, the 4 SDI connectors need to be selected.
Connector(s) is immediately highlighted in blue.
3. The selection is completed by clicking the Done Adding button that is highlighted in blue.
A new Input is added in the input list.
How to delete Output
1. Click on the Delete Output(s) button
The Delete Output(s) button is replaced by the Delete Selected button (highlighted in red).
2. Click on the corresponding connector in the graphical area.
Or,
click in the "x" on the right hand side in the output configuration list.
Connector(s) is immediately highlighted in blue.
3. The deletion is completed by clicking the Delete Selected button.
Multiple connector configurations can be selected to be deleted together.
You can only delete Output Configurations that are not assigned in Destinations.
How to access to the output configuration adjustments
Adjustments to outputs are performed in the "Adjust" panel:
1. Select the output from the configuration list
94 R5905948 E2 12/12/2014