Barco E2 User Manual page 102

6. GUI orientation
Output adjustment panel > Connector Menu
Connector Mapping Defaults:
98
• SDI type (available with SDI connector type) : allows to
choose between Single link or Dual link connection ( Dual
link: single image stream split between the two cables).
• DVI Sync (available with HDMI connector type) : Adjusts
the sync polarity of the H and V sync signals.
• Color/Sample/Bit: Adjust s the color space (RGB or
SMPTE), sampling rate (4:4:4 or 4:2:2) and bit depth of the
output signal.
• HDCP Mode (available with HDMI connector type):
Provides Status of the HDCP compliance.
• Connector Mapping: If more than one output connector are
part of the output configuration, as in a blended widescreen
screen, then the connector mapping menu appears. From
this menu the user can select the appropriate connector
horizontal and vertical arrangement (see default mapping
explanations below).
• In a two connector, 2x1 horizontal configuration: The left
side of the screen is fed by the top or most left connector;
• In a two connector, 2x1 vertical configuration: The top
screen is fed by the top or most left connector.
• In a 4 connector, the default is a 2x2 grid. The top left input
is the left most or top most connector. The bottom left is the
next one, the top right is next, and the bottom right is next.
R5905948 E2 12/12/2014