Barco E2 User Manual page 302

C. Troubleshooting
Problem
Can't read or write to or from the USB drive Incorrect USB format or bad USB
The front panel display screen is too dark display brightness
The unit is not responding to any front
panel button presses.
After factory reset, the IP address is lost
Unable to perform web upgrade
298
Possible cause
Front panel is locked
Wrong mode of the factory reset command
was used
Unable to perform web upgrade
Remedy
Ensure that your flash drive is formatted
to use the FAT32 file system. If you can't
access the USB from a PC, then you have
a faulty USB drive.
Use the "VFD brightness" sub-menu in
the System menu to adjust the intensity of
the front panel vacuum fluorescent display
(VFD) screen.
To unlock the front panel, press and hold
the SEL and ESC buttons simultaneously
for 3 seconds. When the panel is unlocked,
the display screen displays the Status
menu.
Use the "Factory Reset, Save IP" choice
in the "factory reset" sub-menu when you
perform a factory reset.
Make sure E2 connection with the LAN is
available.
Make sure there is an internet access in
the LAN
R5905948 E2 12/12/2014