Barco E2 User Manual page 189

Preparing the flash drive with the upgrade file.
1. Download the software upgrade for free from Barco's website (URL: http://www.barco.com). Click on myBarco and login to get
access to secured information. Registration is necessary.
Note: If you are not yet registered, click on New to myBarco and follow the instructions. With the created login and password,
it is possible to login where you can download the E2 software. It is not necessary to install any other software.
2. Unzip directly the software upgrade downloaded from the Barco website to the USB drive. This operation automatically creates
a directory named E2 with the upgrade file inside (e2_update_vp.xx.xx.tar.gz).
Performing the firmware upgrade using the USB
1. Insert the flash drive into the E2's USB port.
2. Select Firmware Upgrade from the Setup Menu. The Firmware Upgrade submenu appears.
Image 8-2
3. Select USB Code Upgrade. The menu shown in the following illustration appears.
Image 8-3
4. Scroll to the file you want to use, and press SEL.
5. Scroll to Upgrade and press SEL again.
A progress message appears.
6. When the file is loaded, the E2 powers down and reboots.
C
AUTION
R5905948 E2 12/12/2014
:
Do not remove the flash drive or power down the E2 until the firmware file is uploaded.
8. Updating firmware
185