Barco E2 User Manual page 255

Image 10-58
3. Gently pull the Genlock assembly away from the unit . Don't pull the assembly too far back because there are still 2 cables
attached.
Note: At this point there are still 2 cables connecting the Genlock Assembly to the unit.
4. Unlatch the VFD ribbon cable from the connector and pull it up and away from the Genlock board.
Note: This cable connects the Genlock board to the System-Power board.
Image 10-59
5. Unlatch the Ethernet cable from the connector and pull back and away from the Genlock board.
Note: This cable connects the Genlock board to the System-Power board.
R5905948 E2 12/12/2014
10. Maintenance
251