Barco E2 User Manual page 199

In this application only one background is required, but in applications where more than one background is
required, repeat steps 2 thru 6 until done.
C3: Add Input
1. Click on the Input tab to select the inputs that will be defined.
2. Click on the +Add Input blue button to enter the Add mode.
3. Click on the first SDI connector of slot 4 to defined as the camera 1 input.
4. Click on the Done Adding button to exit the Add mode.
5. Double click on Input1 in the Name list to edit the name.
6. When the area turns blue, click the eraser icon to clear the field.
7. Type a new name: "CAM1-Stage". Hit enter when done.
8. Repeat steps 2 thru 6 until done. Enter the names as shown in the image below.
Image 9-7
C4: Add Output
1. Click on the Output tab to select the outputs that will be defined.
2. Click on the +Add Output blue button to enter the Add mode.
3. Click on the first HDMI connector of slot 11.
4. Click on the Done Adding button to exit the Add mode.
5. Double click on Output1 in the Name list to edit the name.
6. When the area turns blue, click the eraser icon to clear the field and type a new name, "DSM". Hit enter when done.
7. Repeat steps 2 thru 6 until done to add the rest of the output connectors with the following names:
- Site projector (SDI, Slot 13–1)
- Main-Left Projector (SDI, Slot 13–3)
- Main-Right Projector (SDI, Slot 13–4)
When you are done the menu should look like this:
R5905948 E2 12/12/2014
9. General operation example
195