Barco E2 User Manual page 30

3. General
a) Measure and install the two supplied mounting brackets on your rear rack rails.
Image 3-2
b) Measure the distance between the front and rear rack rails. Remove the four mounting screws that secure each side rail to
the E2, and then adjust the spacing of each side rail as necessary.
Image 3-3
1 Chassis rear
2 Side rail
3 Mounting screws
c) Re-install the mounting screws. When properly adjusted, the end of each side rail will protrude through the slot in the rear
mounting bracket, once the chassis is rack mounted.
Image 3-4
To take advantage of this feature, ensure that there is at least 1/2" of clearance above the chassis.
Image 3-5
2. For the E2's two keyhole slots, measure and install two rack screws in your equipment rack's front rails. Allow each screw to
protrude approximately 3/4" from the surface of the rails.
3. Lift the chassis, and while supporting it, slide the side rails through the slots in the rear mounting brackets.
26 R5905948 E2 12/12/2014