Barco E2 User Manual page 97

Image 6-24
Output connector colors
Output configuration menu description
Output configuration menu is accessed by clicking on the Output tab.
How to Auto create Outputs
The "Auto Create Outputs" button allows all 2K outputs that are not assigned to an output configuration to automatically assign to an
output configurations. Output connectors that are already assigned to output configurations will not be affected. The picture below
shows what occurs when the button is pressed. Since there are 12 output connectors not assigned, all 12 Output configurations are
automatically assigned. Out1 contains the output connector on the 1st output card in slot 1, etc
R5905948 E2 12/12/2014
Not assigned to any output configuration
Assigned to an output configuration
This menu provides:
• A list of all the outputs already created on the system (e.g. Output1)
• A button to automatically allocate all unassigned output connectors to an
output.
• A button to manually allocate output connector(s) to an output.
• A button to delete unused or obsolete output(s).
6. GUI orientation
93