Barco E2 User Manual page 104

6. GUI orientation
It is possible that after the unit is turned on, the hardware configuration can be altered making certain Destinations to have invalid
Output configurations.
In this case the Destination in the System Diagram becomes grey and adjustment are disabled. In this case the destination needs
to be deleted and new one created to reflect the existing output configuration.
How to add Destination
To assign an output configuration to a destination, select the output configuration (output Tab) and then click on the Add Screen
Destination or the Add Aux Destination button (Destination Tab). These buttons are enabled (highlighted in blue) as long as there
are unassigned output configurations.
Image 6-27
If the Add destination button is pressed without selecting an output configuration, the software will automatically assign the first
unassigned output configuration (from left most output card) to a destination. The output configuration format is copied to the desti-
nation output format.
New Screen or Aux destinations can be added as long as there are unassigned output configurations to destinations.
Alternatively, you assign outputs to destinations by dragging them into the output configuration the Destination block. In the example
below, the output 1 was assigned to ScreenDest1 and the destination format was set to 1920x1080 reflecting the format of output1.
When output 2 is dragged into the same destination, then the format changes to 3820x1080 reflecting a 2x1 setup. When outputs
are dragged into a destination in this matter, the software assumes it is a horizontal setup with 0 pixel overlap. The overlap can
be modified in the ... menu. If a vertical setup is desired, then the output configuration needs to be setup as such in the output
configuration menus.
Image 6-28
How to delete Destination
1. Click on the Delete Destination(s) button
The Delete Destination(s) button is replaced by the Delete Selected button (highlighted in red) and the E2 diagram is greyed
out, except the area dedicated to destinations (Screen and Aux).
2. Click on destination in the graphical area.
100 R5905948 E2 12/12/2014