Table of Contents
Advertisement
Hardware Overview
DC Power Supply
The XP DC power supply delivers 3.3, 5, and 12 volts DC to the XP's control module(s),
fan modules, and other components. A single DC power supply provides enough current
to operate a fully configured chassis.
Figure 6
shows the front view of an XP-8000 DC power supply.
The XP-8000 DC power supply has a three-terminal wiring block on the front panel,
consisting of a positive (+) terminal, negative (-) terminal and a safety ground. The DC
supply is designed to be powered by a 48 Volt DC source. You should use 12- to 14-gauge
wire to connect the 48-Volt source to the XP-8600 DC power supply. You should use 12- to
14-gauge wire for the safety ground.
Figure 7
shows the front view of an XP-8600 DC Power Supply.
16
To be installed in a restricted
!
access area in accordance
with the NEC or authority
having jurisdiction.
See manual for installation
PWR
instructions.
G80-PDC
48/60V
SN
14A MAX
Figure 6. Front view of an XP-8000 DC power supply
To be installed in a restricted
!
access area in accordance
with the NEC or authority
having jurisdiction.
See manual for installation
PWR
instructions.
G86-PDC
SN
48/60V
27A MAX
Figure 7. Front view of an XP-8600 DC power supply
Enterasys Xpedition 8000/8600 Getting Started Guide
Advertisement
Table of Contents
