Table of Contents
Advertisement
Installing the Hardware
b. Use the #2 Phillips screwdriver and two of the supplied Phillips screws to attach
the mounting bracket to the chassis.
c.
Attach the other mounting bracket.
2.
Along with an assistant, lift the chassis into place in the mounting rack.
3.
While your assistant holds the chassis in place, use the #2 Phillips screwdriver and
four #2 Phillips screws to attach the mounting brackets to the mounting rack.
Make sure there are at least 3 inches (7.62 centimeters) of room above and behind
Note:
the unit for air flow to the cooling fans.
: Make sure the screws are tight before your assistant releases the chassis. If you
Caution
accidentally leave the screws loose, the chassis can slip and fall, possibly becoming
damaged.
Installing an AC Power Supply
The primary AC power supply is shipped separately from the XP chassis. To install or
replace the primary AC power supply or if you want to install a redundant power supply,
use the following procedure. You will need a #2 Phillips screwdriver to perform this
procedure.
Use a single-phase grounded power source located within 6 feet (1.89 meters) of
Note:
the installation site.
AC Power Supply Specifications
The following table lists the physical specifications for the XP's AC power supplies.
Dimensions
Weight
Power Output
Voltage Range
Frequency
52
XP-8000
11.00" (L) x 7.70" (W) x 2.55" (H)
6.5 lb (2.95 kg)
300 W
100 to 125 V, 5 A
200 to 240V, 3 A
50 to 60 Hz
XP-8600
12.15" (L) x 7.70" (W) x 5.05" (H)
12.0 lb (5.45 kg)
600 W
100 to 125 V, 10 A
200 to 240 V, 6 A
50 to 60 Hz
Enterasys Xpedition 8000/8600 Getting Started Guide
Advertisement
Table of Contents
