Table of Contents
Advertisement
Installing the Hardware
Control Module RJ-45
RXD (receive data)
Unused
Unused
2.
After ensuring that the pin assignments on both ends of the connection are correct,
plug the appropriate end of the connection into the control module's RJ-45
10/100Base-TX port.
3.
Plug the other end of the connection into the management console's port.
Attaching the Segment Cables
The following sections describe how to connect the XP line cards to your network.
10/100Base-TX Line Card
To attach the segment cables to your 10/100Base-TX line cards:
1.
For all the 10/100-Mbps ports, obtain copper cables that have the following pin
assignments. The RJ-45 connectors on the 10/100Base-TX line cards are configured as
Media Data Interface Crossed (MDIX). You can use Category 3 ("Cat-3") or higher
wire for 10-Mbps segments. For 100-Mbps segments, use Cat-5 or higher wire. The
ports automatically sense which type of segment they are connected to and configure
themselves to transmit and receive at the appropriate bandwidth.
The following table lists the pin assignments for the RJ-45 connector on the
10/100Base-TX and for the RJ-45 connector on the switch, router, or host on the other
end of the segment cable.
Line Card RJ-45 Connector
RXD (receive data)
RXD (receive data)
TXD (transmit data)
Unused
Unused
68
Connector
Pin Number
Management Console RJ-45
6
TXD (transmit data)
7
Unused
8
Unused
Pin Number
RJ-45 Connector at Other
1
TXD (transmit data)
2
TXD (transmit data)
3
RXD (receive data)
4
Unused
5
Unused
Enterasys Xpedition 8000/8600 Getting Started Guide
Connector
End of Segment
Advertisement
Table of Contents
