Table of Contents
Advertisement
5.
Enter the show command to show the commands you just entered. Because you have
not activated these configuration changes yet, they are listed in the scratchpad section
of the show output. Here is an example. Notice that the other configuration changes
made during this CLI session also are listed. Active changes are listed in the "Running
system configuration section" and unactivated changes are listed in the "Non-
committed changes in Scratchpad" section.
ssr(config)# show
Running system configuration:
!
! Last modified from Console on Mon Jun 18 12:37:21 2001
!
1 : interface add ip en0 address-netmask 16.50.11.22/16
!
2 : system set dns server 16.50.11.12
3 : system set dns domain mktg.mrb.com
4 : system set name "xp"
5 : system set location "Houston, TX"
6 : system set contact "John Smith"
7 : system set hashed-password login jNIssH c976b667e681d03ccd5fc527f219351a
8 : system set hashed-password enable zcGzbO 5d1f73d2d478ceaa062a0b5e0168f46a
!
9 : snmp set community public privilege read
10 : snmp set target 16.50.11.12 community public
******** Non-committed changes in Scratchpad ********
1*: system set syslog server 16.50.11.12
2*: system set syslog level info
3*: system set syslog facility local0
6.
To activate the SYSLOG commands, use the save active command. Enter yes to
activate the changes.
Enterasys Xpedition 8000/8600 Getting Started Guide
Setting the SYSLOG Parameters
91
Advertisement
Table of Contents
