5.
Store the DIMMs in an ESD-safe bag or other container and put them in a safe place.
6.
Insert the new DIMMs in the slots, making sure that the contacts are fully inserted
downward into the connector slot.
7.
Install the upgraded control module back into the chassis. (See Installing the Control
Module
Installing the Switching Fabric Module (XP-8600 only)
On the XP-8600, the switching fabric module is shipped separately from the XP chassis. To
install or replace the primary switching fabric module, or if you want to install a
redundant switching fabric module, use the following procedure. You will need a #2
Phillips screwdriver to perform this procedure
The primary switching fabric module must be installed in slot Fabric 1. The redundant
switching fabric module must be installed in slot Fabric 2.
Enterasys Xpedition 8000/8600 Getting Started Guide
on page
59.)
Installing the Hardware
61