Never attempt to rack mount the XP chassis unaided. Ask an assistant to help you
Note:
hold the chassis.
: To make lifting and holding the chassis easier, install the chassis before you install
Caution
line cards or redundant control modules and power supplies.
To install the XP chassis in an equipment rack, use the following procedure. You need a #2
Phillips screwdriver to perform this procedure.
1.
If the front-mounting brackets are already installed on the XP chassis, go to
If not, do the following:
a.
Align one of the mounting brackets over the corresponding holes in the side of
the chassis. The mounting bracket is correctly positioned when the side with two
open mounting holes is flush with the front of the chassis.
Enterasys Xpedition 8000/8600 Getting Started Guide
SSR-16
Figure 24. Installing the XP-8600 chassis in an equipment rack
Installing the Hardware
step
2.
51