Fuses; Electrical Output Terminals; Tool Storage Tray/Battery Hold-Down - Arctic Cat TRV 2015 Operator's Manual

 NOTE: There should be an aver-
age operating load on the ATV
when adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Make vertical marks which intersect
the horizontal marks on the aiming sur-
face directly in front of the headlights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical
mark 5 cm (2 in.) below the horizon-
tal mark on the aiming surface.
7. Adjust each headlight by turning the
adjustment knob clockwise to raise
the beam or counterclockwise to
lower the beam until correct aim is
obtained.

Fuses

The fuses are located in a fuse block
under the seat. If there is any type of
electrical system failure, always check
the fuses first.
 NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse case and lift out.
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
Arctic Cat ATV dealer immediately.
Electrical Output
Terminals
Two output terminals for electrical acces-
sories are located on the front wiring har-
ness and one output terminal for electrical
accessories is located on the rear wiring
harness. The accessory plug is located on
the right side of the instrument pod.
Always use electrical accessories
less than 180W.
Tool Storage Tray/
Battery Hold-Down
A basic tool kit is provided with the ATV.
CD714A
Maintain the tool kit with the ATV at all
times.
The tool storage tray is located beneath
the seat. It also serves as the battery hold-
down.
CAUTION
CAUTION
3411-968
CF157
75