Windshied (Limited); Mirrors (Limited); Rear Seat Lock - Arctic Cat TRV 2015 Operator's Manual

1. Unscrew the oil level stick and wipe
it with a clean cloth.
2. Install the oil level stick and thread it
completely into the engine case.
3. Remove the oil level stick; the engine
oil level should be within the operat-
ing range but not above the FULL
mark.
CAUTION
Do not overfill the engine with oil.
Always make sure the oil level is
within the operating range.

Windshied (Limited)

CAUTION
Remove the windshield before traile-
ring the ATV or damage to the wind-
shield may occur.
To remove the windshield, loosen the left and
right plastic knobs and remove the wind-
shield assembly. Tighten the knobs securely
or remove them completely to prevent loss.
To install the windshield, loosen the left
and right plastic knobs; then install the
tapered windshield pins into the mounts
and tighten knobs securely.
56

Mirrors (Limited)

The mirrors can be adjusted to the desired
viewing angle or moved to a stowed posi-
tion when operating in trees or brush.
Always adjust the mirrors to a position
that will not catch tree branches or
under-brush which could cause a loss
of control and severe injury or death.

Rear Seat Lock

1. To remove the rear seat, pull the two
latch handles to the rear and rotate
them to the vertical position.
GZ461A
2. Lift the rear of the seat up; then pull
slightly to the rear and lift the seat
off the mountings.
3. To lock the seat into position, engage
the two front mounting lugs into the
mounting rack; then, holding down
firmly on the front of the seat, push
the seat forward until the rear tabs
engage the rear mounting latches.
4. Lock the seat into position by rotat-
ing the latch handles to the horizon-
tal position; then push the handles
forward to lock.
CR003
! WARNING
CR017D
CR017E