Arctic Cat TRV 2015 Operator's Manual page 66

3. Remove the drain plug from the bot-
tom of the engine and drain the oil
into a drain pan.
4. Using the oil filter wrench and a
ratchet handle (or a socket or box-
end wrench), remove the old oil fil-
ter and dispose of properly. Do not
re-use oil filter.
 NOTE: Clean up any excess oil
after removing the filter.
5. Apply oil to the new filter seal and
check to make sure it is positioned
correctly; then install the new oil fil-
ter. Tighten securely.
6. Install the engine drain plug and
tighten it securely. Pour the recom-
mended oil in the filler hole. Install the
level stick/filler plug.
7. Start the engine (while the ATV is
outside on level ground) and allow it
to idle for a few minutes.
8. Turn the engine off and wait approx-
imately three minutes. Recheck the
oil level.
9. Inspect the area around the drain
plug and oil filter for leaks.
64
Front Differential And
Rear Drive Lubricant
(Inspecting/Changing)
Check and change the lubricant in each
according to the Maintenance Schedule.
When changing the lubricant, use
approved SAE 80W-90 hypoid oil and
use the following procedure.
 NOTE: To check each, remove
GZ007C
each filler plug. The oil level
should be at the threads of each
plug.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by
removing in turn the drain plug from
each.
733-441A
4. After all the oil has been drained,
install the drain plugs and tighten
securely.
Inspect the oil for any signs of metal
filings or water. If found, take the ATV
to an authorized Arctic Cat ATV
dealer for servicing.
5. Pour recommended oil into each
filler hole.
CAUTION
CF107B
CF106C