Speedometer/Lcd - Arctic Cat TRV 2015 Operator's Manual

Speedometer/LCD

1. Speedometer/Tachometer/Condition
Warning Display - Indicates the
approximate vehicle speed (MPH or
km/h) or RPM. Warns of a system
error condition requiring attention.
The LCD will go blank except the
word VOLT will flash on the LCD
whenever a low voltage (<9 DC volts)
or a high voltage (>16 DC volts) is
detected. When voltage returns to nor-
mal, the gauge must be reset by turning
the ignition key to the OFF position
and then to the ON position.
The letters EFI (digital/analog gauge)
or a diagnostic trouble code (DTC)
(digital gauge) will flash on the LCD
whenever an EFI system error is
detected. After 30 seconds, the gauge
will return to normal, but the letters or
code will continue to flash until the
malfunction is corrected.

NOTE: Take the ATV to an autho-
rized Arctic Cat ATV dealer to have
the error corrected and the system
error reset as soon as possible.
2. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.
54

flashes, approximately 3.5 L (0.92 U.S.
gal.) of gasoline remains in the tank.
Limited
EFI013A
TRV/XT
EFI011B

after releasing either Button, the
LCD will return to normal operation.

supplied through the 15-amp acces-
sory fuse and verified during gauge
"power-up" and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will "power-
up," reset, and shut down repeatedly
until
restored. Always check the 15-amp
accessory fuse if this gauge condi-
tion is noted.
NOTE: When the bottom segment
3. Mode Button - Press and release to
shift the gauge between MPH or km/h
and RPM. Press and hold to switch
beetween MPH and km/h.
4. Set/Reset Button - Press and release
to shift betwen Odometer, Trip 1, Trip
2, Engine Hour Meter, and Clock.
Press and hold while Trip 1 or Trip 2
are selected to clear the selected trip.
The odometer cannot be reset.
5. Odometer/Trip Meter/Clock/Engine
Hour Meter - Displays odometer
(total distance the vehicle has trav-
eled) or one of two trip meters used to
measure trips or trip legs correspond-
ing to the function selected (MPH or
km/h). The clock function indicates
time in the 12 hour mode. The hour
meter indicates the total time the ATV
has run and cannot be reset to zero.
To set the clock, use the following
procedure.
A. With the ignition switch ON, press
and release the Mode Button (3)
until the Clock/Engine Hour Meter
(1) is displayed; then (if necessary)
press and release the Set/Reset
Button (4) to the clock display.
B. Press and hold Set/Reset Button (4)
until minutes stop scrolling and the
hour display starts to scroll.
Momentarily release when correct
hour is displayed; then repeatedly
press and release Set/Reset Button
until correct minutes are displayed.
NOTE: Approximately two seconds
NOTE: Clock memory power is
clock memory power is