Oil Level Stick - Arctic Cat TRV 2015 Operator's Manual


NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
6. Gear Position Indicator - Indicates
which gear is selected - R (reverse)/N
(neutral)/H
range)/P (park).

NOTE: An E will be displayed if
there is an error caused by a no-shift
position signal.
7. Engine Hour Meter Indicator - Indi-
cates engine hour meter mode is
selected on the display.
8. Speedometer/Tachometer Indicator -
Indicates which mode (MPH, km/h,
or RPM) is being displayed.
9. 4WD Lock Indicator - Displays
LOCK when the front differential
lock has been engaged.
10. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the 4WD lock
is engaged. The display is blank when
in 2WD.
11. High Beam Indicator - Appears when
the headlights are on high beam.
12. Temperature Indicator - The speedom-
eter/tachometer needle will sweep full
scale and the LCD will go blank except
the high temperature icon will flash.
After 30 seconds, the speedometer/
tachometer needle and LCD will return
to normal, but the temperature icon will
continue to flash. The icon should not
be visible during normal operation.
CAUTION
Continued operation with high engine
temperature may result in engine
damage or premature wear.

NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
engine temperature.
engine RPM, reducing load, and
selecting an appropriate transmis-
sion gear can lower the temperature.
(high range)/L
Decreasing

NOTE: Debris in front of the engine
(or packed between the cooling fins of
the radiator) can reduce cooling
capacity. Using a garden hose, wash
the radiator and the engine to remove
any debris restricting air flow.
(low
Arctic Cat does not recommend
using a pressure washer to clean the
radiator core. The pressure may bend
or flatten the fins causing restricted
air flow, and electrical components
on the radiator could be damaged.
Use only a garden hose with spray
nozzle at normal tap pressure.
13. Odometer/Trip Meter Indicator Dis-
play - Displays which function (ODO,
Trip, or Trip 2) is selected.
14. Speedometer/Tachometer
(digital/analog gauge) - Indicates
approximate vehicle speed in MPH or
km/h when speedometer function is
selected or RPM when tachometer
function is selected. Sweeps full-scale
whenever an EFI system error is
detected.
Wrench Indicator (digital gauge) -
Displayed in conjunction with a DTC
whenever an EFI system error is
detected.
Electric Fuel Pump
An electric fuel pump is incorporated in
the gas tank to deliver gasoline to the fuel
injector. The fuel pump is activated when
the ignition switch is in the ON position.
 NOTE: Both the ignition and fuel
pump functions will be interrupted by
the Tilt Sensor if the ATV tips over
past 60°-70°. Righting the ATV will
reactivate the ignition and fuel pump.

Oil Level Stick

There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.
 NOTE: The ATV should be on
level ground when checking the
engine oil level.
CAUTION
Needle
55