Arctic Cat TRV 2015 Operator's Manual page 70

6. If using the CTEK Multi US 800,
there are no further buttons to push.
If using the CTEK Multi US 3300,
press the Mode button (A) at the left
of the charger until the Maintenance
Charge Icon (B) at the bottom illu-
minates. The Normal Charge Indica-
tor (C) should illuminate on the
upper portion of the battery charger.
 NOTE: The maintainer/charger
will charge the battery to 95%
capacity at which time the Mainte-
nance Charge Indicator (D) will illu-
minate and the maintainer/charger
will change to pulse/float mainte-
nance. If the battery falls below
12.9 DC volts, the charger will
automatically start again at the
first step of the charge sequence.
 NOTE: Not using a battery char-
ger with the proper float mainte-
nance will damage the battery if
connected over extended periods.
Charging
 NOTE: Arctic Cat recommends
the use of the CTEK Multi US 800
or the CTEK Multi US 3300 for bat-
tery maintenance charging.
68
1. Be sure the battery and terminals
have been cleaned with a baking
soda and water solution.
2. Be sure the charger and battery are
in a well-ventilated area. Be sure the
charger is unplugged from the 110-
volt electrical outlet.
3. Connect the red terminal lead from
the charger to the positive terminal
of the battery; then connect the black
terminal lead of the charger to the
negative terminal of the battery.
4. Plug the charger into a 110-volt elec-
trical outlet.
5. By pushing the Mode button (A) on
the left side of the charger, select the
Normal Charge Icon (E). The Nor-
mal Charge Indicator (C) should
800E
illuminate on the upper left portion
of the charger.
6. The battery will charge to 95% of its
capacity at which time the Mainte-
nance Charge Indicator (D) will illu-
minate.
 NOTE: For optimal charge and
performance, leave the charger
connected to the battery for a mini-
mum 1 hour after the Maintenance
Charge Indicator (D) illuminates. If
the battery becomes hot to the
touch, stop charging. Resume
after it has cooled.
7. Once the battery has reached full
charge, unplug the charger from the
110-volt electrical outlet.
 NOTE: If, after charging, the bat-
tery does not perform to operator
expectations, bring the battery to
3300A
an authorized Arctic Cat dealer for
further troubleshooting.