Rear Foot Brake; Throttle Lever; Engine Stop Switch; Electric Starter Button - Arctic Cat TRV 2015 Operator's Manual

Rear Foot Brake

Pressing the rear foot brake downward
will apply the brake to the rear wheels.
Headlight HI/LO Switch
Use the headlight HI/LO switch to select
the high or low headlight beam when the
ignition switch is in the LIGHTS posi-
tion. When the switch is in the HI posi-
tion, the high beam will illuminate. When
the switch is in the LO position, the low
beam will illuminate.

Engine Stop Switch

OFF position — The ignition circuit is off.
The engine cannot be started or will not
run. If the engine stop switch is used to
stop engine without turning off ignition
switch, the battery may discharge.
RUN position — The ignition circuit is
on. The engine can start and run.

Electric Starter Button

Pushing in on this button activates the
starter motor. Before starting the engine,
make sure the ignition switch is in the ON
position, the transmission is in neutral, the
reverse shift lever is in the forward posi-
tion, and the brake lever lock is engaged.
52
 NOTE: This ATV has safety inter-
lock switches which prevent the
starter motor from activating when
the transmission is not in neutral.
To start the ATV while in gear,
depress the rear foot brake or
compress the brake lever; then
depress the starter button.
Reverse Override Switch
This ATV is equipped with a reverse
speed limiter system. When additional
CF223
RPM is needed in reverse, depress and
hold the override switch.
 NOTE: The override is active
only when 4WD is selected.
Never activate the override switch
while the throttle is open as a loss of
control may result.

Throttle Lever

CF245A
Control engine RPM with the position of
the throttle lever. Operate this lever with
the thumb. Pushing it forward increases
engine RPM and allowing it to retract
decreases engine RPM.
Throttle Limiter Screw
Throttle lever travel may be limited by
adjusting the throttle limiter screw. The
throttle limiter should be adjusted
according to the operator's skill and
experience. To adjust the throttle limiter,
use the following procedure.
1. Loosen the jam nut.
! WARNING
FI475B