Introduction - Magnum Energy RD-E Series Owner's Manual

Introduction

1.0 Introduction
Congratulations on your purchase of the RD-E Series inverter/charger from Magnum Energy. The
RD-E Series is a modifi ed sine wave inverter designed especially for renewable energy systems.
Powerful, yet simple to operate, this inverter/charger will provide you with the years of trouble-
free performance you have come to expect from Magnum Energy, all backed by our limited 2 year
warranty.
Installation is easy. Simply connect the inverter's output to your distribution circuits or electrical
panel, connect your utility or AC generator power to the inverter's easy-to-reach terminal block,
connect the batteries, and then switch it on for power.
Use the optional accessories listed below to control and monitor many other Magnum devices.
The RD-E Series inverter/charger includes:
• 2600 or 4000 watt models in a small footprint – less weight and area needed for installation
(shelf, bulkhead, or upside-down mounting)
• Modifi ed Sine Wave output
• Automatic Power Factor Corrected (PFC) multi-stage battery charging
• RS485 standard communication protocol
• Remote and Network ports (easy connection for optional accessories)
• ON/OFF inverter-mounted switch with LED indicator
• 30 Amp per leg/input
• Large AC access and terminal block [wire size: 10 to 6 AWG (5.3 to 13.3 mm
• DC terminal covers with 360 degree connection
• Field-serviceable for qualifi ed personnel – tested repair kits available
• Automatic battery temperature compensation (using battery temperature sensor) – for
optimum charging even during extreme temperature changes
• Overcurrent, over-temperature, and high/low battery voltage protection
The following accessories are also available for use with the RD-E Series inverter/charger:
• ME-RC50 (Basic Remote Control) - easy to read LCD display panel that enables standard
inverter and accessories set up, control, and troubleshooting.
• ME-ARC50 (Advanced Remote Control) - easy to read LCD display panel that enables advance
inverter and accessories set up, control, and troubleshooting.
• ME-AGS-N (Automatic Generator Start Module - Network version) - automatically starts/stops
your generator.
• ME-BMK (Battery Monitor Kit - with Shunt) - provides precise DC voltage/current measurements
and provides information on your battery's State of Charge (SOC) condition.
• MPX-CB (Conduit Box) - provides several knockouts for connecting AC and DC conduit runs
to the inverter.
• ME-SBC (Smart Battery Combiner) -
portion of the current that is charging a main battery.
• MMP (Mini Magnum Panel) -
energy system into a single, easy to install pre-wired enclosure.
Page 1
monitors and keeps a second battery charged using a
combines all of the major components required for a renewable
) CU]
2
© 2010 Magnum Energy, Inc