5800 Series Transmitter Input Loop Identification - ADEMCO VISTA-20P Installation And Setup Manual

5800 Series Transmitter Input Loop Identification

All of the transmitters illustrated below have one or more unique factory assigned input (loop) ID codes. Each of the input
loops requires its own programming zone (e.g., a 5804's four inputs require four programming zones).
LOOP 3
LOOP 2
LOOP 1
LOOP 4
YOU MUST
ENROLL THIS
BUTTON
ENROLL AS "UR" OR "RF"
5 8 0 1
ENROLL AS "UR" OR "RF"
LOOP 3
YOU MUST
ENROLL THIS
BUTTON
LOOP 2
LOOP 4
LOOP 1
5 8 0 4
ENROLL
AS "BR"
LOOP 3
5 8 0 4 B D
ENROLL AS "BR"
LOOP
1
5809
ENROLL AS "RF"
LOOP
1
5808
ENROLL AS "RF"
ENROLL AS "RF"
Compatible 5800 Series Transmitters Table
Model Product
5801 Wireless Panic
Transmitter
5802 Pendant
Emergency Transmitter)
5802CP Belt Clip (Personal
Emergency)
5802MN Miniature (Personal
Emergency Trans.)
5804 Wireless Key
Transmitter
5804BD Bi-Directional
Wireless Key
5806
Wireless
5807
Photoelectric Smoke
5808
Detectors
5809 Heat Detector
5816 Door/Window
Transmitters
5816MN
5816TEMP Low-Temp. Sensor
LOOP
2
(REED)
LOOP 1
(TERMINALS)
LOOP
1
ALTERNATE
5 8 1 6 M N
POSITION
ENROLL AS "RF"
FOR LOOP2
5 8 0 2 M N
LOOP
2
(REED)
LOOP 1
(TERMINALS)
LOOP 2
YOU MUST
ENROLL THIS
LOOP 3
BUTTON (TERMINALS)
5 8 1 9
LOOP 4
ENROLL AS "RF"
LOOP 1
•
• •
• •
•
• • • SET
5 8 2 7
• • •
•
•
HOUSE
SET HOUSE CODE
CODE
LOOP
2
(REED)
LOOP 1
(TERMINALS)
(Green)
(Red)
(Yellow)
5 8 1 6
5 8 5 0 ( G B D )
ENROLL AS "RF"
Input Type
UR or RF
BR Only
(Personal
BR Only
UR or RF
BR Only
BR
RF
RF
RF
RF
NOTE: For information on any transmitter not
LOOP
shown, refer to the instructions accompanying
1
(PRIMARY)
that transmitter for details regarding loop
2
(AUX. CENTER)
numbers, etc.
3
(AUX. RIGHT)
5 8 1 7
UL NOTE: The following transmitters are
ENROLL AS "RF"
LOOP
2
(REED)
LOOP 1
(INTERNAL
SHOCK
LOOP 3
SENSOR)
(TERMINALS)
5 8 1 9 S ( W H S & B R S )
ENROLL AS "RF"
5 8 2 7 B D
SET HOUSE CODE
LOOP
1
(MOTION)
5 8 9 0
ENROLL AS "RF"
Description
• Four pushbuttons, each with a unique input (loop) code.
• Programmable responses (e.g., Panic, Arm, Disarm, etc.)
• Has single pushbutton.
• Usually programmed for response type of 24-Hr audible or 24-Hr
Silent (other zone responses are possible).
Same as 5802.
Same as 5802.
• Has four pushbuttons, each with a unique input (loop) code.
• Programmable responses (e.g., Arm, Disarm, etc.)
• House ID must be set.
• Requires 5800TM Transmitter Module.
• Can indicate system status via its 2 LEDs and built-in sounder.
• Has four pushbuttons, each with a unique input (loop) code.
• Operates the system similarly to wired keypads.
One-piece smoke detectors with a built-in transmitter.
One-piece rate-of-rise heat detector with a built-in transmitter.
Has two unique input (loop) codes: one for a wired closed circuit
contact loop; the other for its built-in reed switch (used with a
magnet).
Transmits a fault condition when temperature drops below 45°F.
not intended for use in UL
installations:
5802MN, 5802MN2, 5804,
5804BD, 5814, 5816TEMP,
5819, 5819WHS & BRS,
5827BD, and 5850.
14-3