Section 7. Zone Lists ( 81 Menu Mode); About Zone Lists; Zone List Programming - ADEMCO VISTA-20P Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

About Zone Lists

Zone lists let you group individual zones for use with certain system actions. The following table
shows the available zone lists and their purposes:
List No. Used for...
1, 2 general purpose
3 chime-by-zone
4 cross zones
5 night stay zones
6, 7, 8 general purpose
9 zones that activate pager 1
10 zones that activate pager 2
11 zones that activate pager 3 (VISTA-20P only)
12 zones that activate pager 4 (VISTA-20P only)

Zone List Programming

Zone List programming involves:
1. Selecting an appropriate zone list number;
2. Adding the desired zone numbers to be included in that list.
Start Zone List Program Mode by pressing
prompts are displayed :
*81 Menu Mode
PROMPT
Zone List No.
(00 = Quit) 01
01 Enter Zn Num.
(00 = Quit) 00
01 Del Zn List?
0 = No 1 = Yes 0
01 Delete Zone?
0 = No 1 = Yes 0
01 Zn to Delete?
(00 = Quit) 00
VALID ENTRIES
Zone List Number
01-12 = zone list number
[∗] to continue
Zone Number
†
01-64 = zone numbers
followed by [∗] to
accept each zone
00 to continue
Deleting Zone Lists
0 = don't delete list
1 = delete this zone list
[∗] to continue
Deleting a Zone
0 = don't delete zones
1 = go to next prompt to delete
zones
[∗] to continue
Delete the Zone
†
01-64 = zones to be deleted
from list followed by [∗]
to accept each zone
00 to continue
✱ 81 while in Data Programming mode. The following
EXPLANATION
Enter the Zone List Number to program (or 00 to end these entries).
Press [ ✱ ] to advance.
In the following displays, zone list 01 has been selected for
programming.
Enter each zone number to add to the zone list, followed by pressing
[ ✱ ] (example, 01 ✱ , 02 ✱ , 03 ✱ ). After all zones are entered, press 00 to
continue.
IMPORTANT: Do not include fire zones in zone lists that are used
to STOP device actions.
† VISTA-20P = 01-64; VISTA-15P = 01-40.
To delete the zone list, enter 1. All zones in the zone list will be
deleted automatically and the system returns to the Zone List No.
prompt.
To save the zone list, enter 0.
To save the entire zone list, enter 0 and the system returns to the
Zone List No. prompt.
To delete a zone or zones in a zone list enter 1 to continue.
Enter each zone to be deleted from the list, followed by [ ✱ ]. After all
zones to be deleted are entered, enter 00 to return to the Zone List
No. prompt. so that another list can be programmed, if desired.
† VISTA-20P = 01-64; VISTA-15P = 01-40.
S E C T I O N
Zone Lists
(∗81 Menu Mode)
7-1
7