4219/4229 Expansion Zones - ADEMCO VISTA-20P Installation And Setup Manual

4219/4229 Expansion Zones

1. Connect each module to the control's keypad
terminals.
2. Assign each module a unique device address using its
DIP switches. Zone numbers are based on the device
addresses listed in the table below.
Expander Module Addresses
For Zones...Set Module to Device Address...
09-16 07
(not available if zone-doubling enabled)
17-24 08
25-32 09 (VISTA-20P only)
33-40 10 (VISTA-20P only)
41-48 11 (VISTA-20P only)
3. Connect sensors to the module's loops.
4. If using relays with the 4229, connect the desired
field wiring to the unit's relay contact terminals.
RELAY
CONNECTOR
RLY RLY
2
RELAYS
"OFF"
RELAY
DIP SWITCH
2
FOR SETTING ADDRESS
AND ZONE "A" RESPONSE
}
RELAY
1
NO C NC
}
TAMPER JUMPER POSITION
4229 IN CABINET
(NOT TAMPERED)
4229 REMOTE
(TAMPER PROTECTED)
1 2 3 4 5
REED
1
(TAMPER)
SWITCH
1K
A B C D
ZONES:
Figure 8. Wiring Connections, 4219 & 4229 (4229 shown)
Mounting and Wiring the Control
Notes
• Supports expansion zones (NO or NC) using
4219/4229 Zone Expander Modules as follows:
VISTA-20P: Up to 40 expansion zones using up
to five Zone Expander Modules.
VISTA-15P: Up to 16 expansion zones using up
to two Zone Expander Modules.
• Use 1000 ohm end-of-line resistors at the end of
loops connected to the 4219/4229 modules. (End-
of line resistors used on the control terminals are
2000 ohms.)
• Expansion zones have normal response time
(300–500 msec), except zone connected to each
module's loop "A," which can be set for fast
response (10–15 msec).
4229
EITHER OR BOTH CAN BE USED
TB2
4-PIN CONSOLE PLUG
GRN DATA OUT
4
BLK
4 3
3
RED
2
2
TB1
YEL DATA IN
1
1
6 7 8 9 10 11 12
TERMINATE EACH
PROGRAMMED ZONE
WITH 1000 OHM (1K)
END-OF-LINE RESISTOR
(EACH ZONE'S MAX.
LOOP RESISTANCE:
300 OHMS + E.O.L.)
E F G H
TERMINALS ON
CONTROL PANEL
(TERM 6)
TO CONTROL
(–) GROUND (TERM 4)
(+) 12V (TERM 5)
FROM (TERM 7)
CONTROL
2-7