ADEMCO VISTA-20P Installation And Setup Manual page 48

Installation Instructions
Start Output Device Mapping by pressing *79 while in Data Programming Mode. The following
prompts are displayed:
∗79 Menu Mode
PROMPT
ENTER OUTPUT NO.
00 = QUIT xx
XX OUTPUT TYPE
0 = rly, 1 = X10 0
"A"
XX UNIT No.
yy
"B"
XX MODULE ADDR
07-15 yy
XX REL POSITION
1-4 zz
6-2
VALID ENTRIES
Device Output Number
01-16 = VISTA-20P relays/X-10
01-08 = VISTA-15P relays/X-10
[∗] to continue
Output Type
0 = delete
1 = relay on 4204/4229 module
2 = Powerline Carrier device
[∗] to continue
Unit Number
01-16 = predefined address
[∗] to continue
Module Address
07-15 = predefined address
[∗] to continue
Relay Position
1-4 = relay position
[∗] to continue
EXPLANATION
This is the logical (or reference) relay number as used in the system.
Relays and X-10 devices are numbered 01-16; the on-board triggers
are numbered 17 and 18 and are factory set. Use the worksheet on
the Programming Form (printed separately) to organize device
numbers.
Select whether this is a relay or a Powerline Carrier (X-10) device.
If X-10 is selected, go to "A" prompt.
If relay is selected, skip to "B" prompt.
If X-10 is selected, a prompt for the unit number appears.
Enter the unit code (set at the device) and press [∗].
The system returns to the Output Number prompt.
If relay is selected, this prompt appears.
Enter the predefined address for this module as listed below. Make
sure the module's DIP switches are set to the selected address.
Module Addresses
Address Module
07 1st 4229 (with zones 09-16)
08 2nd 4229 (with zones 17-24)
†
09 3rd 4229 (with zones 25-32)
†
10 4th 4229 (with zones 33-40)
†
11 5th 4229 (with zones 41-48)
12 1st 4204
13 2nd 4204
†
14 3rd 4204
†
15 4th 4204
This is the actual (or physical) relay number with respect to the
Relay Module upon which it is located. For 4204 modules, relay
numbers are 1-4. For 4229 modules, relay numbers are 1-2.
The system returns to the Output Number prompt for programming
the next device.
† These addresses
apply to the VISTA-20P
only.