Section 12. System Operation; Security Codes - ADEMCO VISTA-20P Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

Security Codes

The VISTA-20P system supports up to 48 security codes (VISTA-15P supports 32 codes), which can
each be assigned one of 5 authority levels. The authority level determines the functions each code
can perform as follows:
Authority Levels
Level User No.
Installer
System 02
Master
Partition P1 = 03
Master P2 = 33
(default)
0-User
03-49
03-33
1-Arm Only see "user"
2-Guest see "user"
3-Duress see "user"
4-Partition see "user"
Master
Refer to the user guide for detailed procedures on adding/deleting security codes and changing user
attributes.
The following is a brief description of how to add user codes.
Adding a User Code:
Deleting a User Code: Master code + [8] + 2-digit user no. + [#] [0]
Assigning Attributes: Master code + [8] + 2-digit user no. + [#] [attribute no.] + value
arm/disarm.
(authority levels can be assigned to users 3-49 only; users 1 and 2 cannot be changed)
Functions
01 perform all security functions except can disarm only if used to arm;
can enter program mode (default=4112)
only one system master code per system; can perform all security
functions, add/delete users in either partition, change master code, view
event log, set system clock, program keypad macro, program scheduled
events, activate output devices (triggers/relays)
VISTA-20P only. Same as Master, except add/delete users limited to
assigned partition only, (these users can be assigned different authority
levels, if desired; any user can be assigned the partition master authority
level)
perform security functions (arm, disarm, etc.) only; cannot add/delete
)
(V20P
users, view event log, set system clock or program scheduled events
(V15P)
arm system only
can disarm the system only if it was used to arm the system
performs security functions, but also silently sends a duress message to
the central station; reports as zone 92
VISTA-20P only. See Partition Master paragraph above; used to assign
other user numbers as partition masters
Master code + [8] + 2-digit user no. + user's code
Attributes:
1 = Authority Level
2 = Access Group
3 = Active Partition(s)
for this user;
4 = RF Zone No.
5 = Open/Close Paging
System Operation
Values
0-4 (see Authority Level table above)
0-8 (0 = not assigned to a group)
1, 2, 3 (common)
Enter partitions consecutively if more than one
and press [#] to end the entries.
Assigns user number to button type zone for
1 for yes, 0 for no
S E C T I O N 1 2
12-1