Advantech i915GV-INA Series User Manual page 51

Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
x EPP Mode Select
x EPP Mode Use DMA
PWRON After PWR-Fail
: Move Enter:Select
F5: Previous Values
Onboard FDC Controller [Enabled]
When [Enabled], this field allows you to connect your floppy disk drives to the
onboard floppy disk drive connector instead of a separate controller card. If you
want to use a different controller card to connect the floppy disk drives, set this
field to [Disabled]. Configuration options: [Enabled] [Disabled]
Onboard Serial Port 1 /2 [3F8/IRQ4] / [2F8/IRQ3]
The settings are [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3] and [Disabled] for
the onboard serial connectors.
Onboard Parallel Port [378/IRQ7]
This field sets the address of the onboard parallel port connector. you can select
[378/IRQ7] [278/IRQ5] [3BC/IRQ7] or [Disabled]. If you install an I/O card with a
parallel port, make sure there is no conflict in the address assignments. The single
board computer can support up to three parallel ports.
Parallel Port Mode [SPP]
This field allows you to set the operation mode of the parallel port. The setting
[Normal] allows normal speed operation, but in one direction only. [EPP] allows
bidirectional parallel port operation at maximum speed. [ECP] allows the parallel
port to operate in bidirectional mode and at a speed faster than the maximum data
transfer rate. [ECP + EPP] allows normal speed operation in a two-way mode.
PWRON After PWR-Fail [Former-Sts]
Use this to set up the system after power failure. The [Off] setting keeps the
system powered off after power failure, the [On] setting boots up the system after
failure, and the [Former-Sts] returns the system to the status before power failure.
i915GV-INA
Phoenix - Award BIOS CMOS Setup Utility
Phoenix - Award BIOS CMOS Setup Utility
SuperIO Device
OnChip IDE Device
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
[EPP1.7]
[3]
[Former-Sts]
+/-/PU/PD:Value
F6: Fail Safe Defaults
Item Help
Menu Level
F10:Save ESC:Exit
F7: Optimized Defaults
F1:General Help
2-13