Serial Ata Connectors (7-Pin Sata1 [Red], Sata2 [Red], Sata3 [Black], Sata4 [Black]) - Advantech i915GV-INA Series User Manual

4. Serial ATA connectors
(7-pin SATA1 [red], SATA2 [red], SATA3 [black],
SATA4 [black])
These connectors are for the Serial ATA signal cables for Serial ATA hard
disk drives.
Important notes on Serial ATA
• You must install Windows
Service Pack1 before using Serial ATA hard disk drives.
• When using the connectors in standard IDE mode, connect the primary (boot)
hard disk drive to the SATA1 connector. Refer to the table below for the
recommended hard disk drive connections.
Serial ATA Master/Slave connectors
Connector
SATA1, SATA2
SATA3, SATA4
i915GV-INA
2000 Service Pack 4 or the Windows
®
Color
Red
Black
®
XP
Setting
Master
Slave
1-25