2.5
Integrated Peripherals
The Integrated Peripherals menu items allow you to change the onboard devices
configuration settings.
OnChip IDE Device
Onboard Device
SuperIO Device
: Move
F5: Previous Values
IDE HDD Block Mode
IDE DMA transfer access
On-Chip Primary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
*** On-Chip Serial ATA Setting
On-Chip Serial ATA
x
PATA IDE Mode
SATA Port
: Move
F5: Previous Values
IDE HDD Block Mode [Enabled]
Enables or disables IDE HDD Block mode. Configuration options:
[Enabled][Disabled]
IDE DMA Transfer Access [Enabled]
Enables or disables IDE DMA Transfer Access. Configuration options:
[Enabled][Disabled]
On-Chip Primary PCI IDE [Enabled]
Enables or disables primary PCI IDE support.
Configuration options: [Enabled] [Disabled]
2-10
Phoenix - Award BIOS CMOS Setup Utility
Integrated Peripherals
[Press Enter]
[Press Enter]
[Press Enter]
Enter:Select
+/-/PU/PD:Value
F6: Fail Safe Defaults
Phoenix - Award BIOS CMOS Setup Utility
Phoenix - Award BIOS CMOS Setup Utility
OnChip IDE Device
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
***
[Enhanced Mode]
Primary
P1,P3 is Seconary
Enter:Select
+/-/PU/PD:Value
F6: Fail Safe Defaults
F10:Save
OnChip IDE Device
F10:Save
Item Help
Menu Level
ESC:Exit
F1:General Help
F7: Optimized Defaults
Item Help
Menu Level
If your IDE hard drive
supports block mode
select Enabled for
automatic detection of
the optimal number of
block read/writes per
sector the drive can
support.
ESC:Exit
F1:General Help
F7: Optimized Defaults
Chapter 2: BIOS setup