Modifying Edit Points - Sony DSR-2000AP Operating Instructions Manual

To display the duration between two edit points

Modifying Edit Points

1
Press the RECORDER button or PLAYER button to select the VCR on
which you wish to check the duration.
The button you have pressed lights.
2
Hold down any two of the four edit point buttons (recorder or player
IN, OUT, audio IN, and audio OUT points).
While you hold down the buttons, the duration between the two edit
points is shown in the display section.
When only one of the two selected edit points is set
The duration between the edit point and the current tape position is
displayed.
When neither of the two selected edit points is set
The duration between the most recently set corresponding edit points is
displayed.
Once you set edit points, you can modify or delete them as required.
When edit points have been set incorrectly, for example when an OUT
point is located before an IN point or when the duration of editing
segments on the player and recorder do not match, the DELETE button
flashes to alert you that a preview or edit cannot be carried out. In this
case, either modify the erroneous edit point, or first delete it and then enter
it correctly.
To turn a flashing DELETE button off
The DELETE button goes off when the erroneous edit point is correct.
75
Chapter 4 Editing