Table of Contents
Advertisement
User Manual
Arctic Substation Gateway
■
WAN Failover - Secondary Backup WAN Interface (selection: None/Mobile
WAN/Ethernet WAN/Ethernet WAN Secondary)
■
These three settings configure the high level default gateways. Must be
configured to enable default route.
■
OpenVPN Client Settings - Interface (selection: Any WAN/Ethernet WAN/
Wireless WAN/Ethernet LAN)
■
Which Interface to use for connection
■
OpenVPN Client Settings - Routing mode (selection: None/host/net/default
route)
■
This defines how the routing is configured with OpenVPN. See
OpenVPN application note.
4.2.2 Default route
Default route can be configured from WAN Failover screen. See section
Failover
4.2.3 WAN redundancy/failover
To configure redundancy between WAN interfaces, configure multiple WAN
interfaces to WAN Failover. See section
4.2.4 Routing serial <-> Ethernet
See section
gateway.
4.3 Network services
4.3.1 DNS proxy
To use this feature, configure the device to use Arctic Substation Gateway
Ethernet LAN IP address as its DNS server. This way, the DNS queries from
the device get routed through the Arctic Substation Gateway.
4.4 Network status information
4.4.1 System status screen
Network status information can be seen from System > Status screen .
Firmware Version 2.4.x
on page 25.
Configuring serial gateway
WAN Failover
on page 31 for configuring serial
28
WAN
on page 25.
Document Version 1
Advertisement
Table of Contents
