Table of Contents
Advertisement
User Manual
Arctic Substation Gateway
6 Additional System Configuration
6.1 Changing system password
Username and password can be changed from Tools->User Config screen.
It is always recommended to change the password from the factory default
when the Arctic Substation Gateway is connected to a public network.
Also console access password can be changed.
Figure 22. User Config screen
6.2 Date and time
Date and time can be changed from System->Time screen. Date and time
can be configured either manually entering the time or automatically from
connected PC.
Figure 23. System time configuration screen
To set time manually, enter the time and then press Submit button.
To copy time from PC, press Copy PC button and answer "Yes" to question
about changing time. Note that the PC may not necessarily have correct time
set and that needs validation. Also note that the copy functionality requires
JavaScript support from the browser.
6.3 System log
System log is visible on the Tools->System Log screen. To refresh the system
log, use web browser reload button.
6.4 Factory default settings
Factory default settings can be applied by restarting the unit pressing down
reset button until the LEDs blink.
6.5 Firmware update
Current running firmware version can be viewed from the System->Status
screen.
Arctic Substation Gateway firmware can be updated from the Tools-
>Firmware Update screen.
Firmware Version 2.4.x
32
Document Version 1
Advertisement
Table of Contents
