Configuring Default Gateway - Viola Systems Arctic Substation Gateway User Manual

User Manual
Arctic Substation Gateway

3.6 Configuring default gateway

1. Select Network->WAN Failover from the left menu.
2. Set "WAN Default Route"="Yes". This has to be enabled to use either
WAN as default route interface.
3. If the mobile WAN has to be set as a default gateway, set "Primary WAN
Interface"="Mobile WAN".
4. If Ethernet WAN has to be set as a default gateway, set "PrimaryWAN
Interface"="EthernetWAN".
5. If both Ethernet WAN and Mobile WAN configured, define the Backup
WAN Interface. If the primary WAN interface comes down, Arctic
Substation Gateway automatically switches default route to backup WAN
interface. The figure below shows example configuration where Ethernet
WAN is configured as default route.
Figure 11. Ethernet WAN default route example
6. Press Submit on the bottom to save the settings.
7. Select Tools->Reboot from the left menu and press Reboot button to
restart the unit.
Firmware Version 2.4.x 22 Document Version 1