Table of Contents
Advertisement
User Manual
Arctic Substation Gateway
Note!
If the SIM card requires a PIN code, do not install the SIM card before you
set up the Arctic Substation Gateway device PIN code settings. The SIM card
may become locked if the settings are not made first.
Arctic Substation Gateway wireless connection requires SIM card with data
transfer service enabled. The device can use two SIM cards, which can be
used to make connection to two different operators. Arctic Substation Gateway
can be operated using only one SIM card.
To operate with SIM card follow the procedure below:
1. Power off the Arctic Substation Gateway.
2. The SIM card holder contains a tray with a yellow eject button. Push this
button to eject the tray from the holder.
3. Put the SIM card onto the tray.
4. Insert the tray carefully back to the holder and press the tray until it is
locked.
If two SIM cards are used, repeat the procedure for SIM slot 2.
2.10 DIN rail mounting
Arctic Substation Gateway has mounting holes for optional DIN rail mounting
brackets. Viola Systems order code for DIN rail mounting kit is 3003. Contact
the local Viola Systems distributor for more details.
Mounting instructions:
1. Required tools and accessories are: DIN rail mounting kit (2 mounting
brackets and 4 screws), screw driver.
2. Use the screw driver to attach the screws to bthe ottom panel of the Arctic
LTE. DIN rail brackets are installed to either diagonally or horisontally
depending on the wanted DIN rail installation angle.
2.11 Product label
Product label is found on the bottom of the device and it contains the basic
information about the unit such as product name, serial number and Ethernet
MAC address.
Figure 8. Product label
Firmware Version 2.4.x
17
Document Version 1
Advertisement
Table of Contents
