Starting Up From A Local Pc - Alcatel-Lucent Extended Communication Server Installation & Configuration Manual

Chapter
2
The Linux Kernel starts up.
5. At the login prompt:
• Type the default identifier: superadmin
• Type the default password: %rV&A1uc
• Click OK
The integrated Web browser starts up.
6. A message warns you that you are about to enter a secured session. Click yes to continue.
7. A login dialog box is displayed:
• Type the default identifier: superadmin
• Type the default password: %rV&A1uc
• Click OK
You have now access to the administration interface.
2.3

Starting Up from a Local PC

To start up the Extended Communication Server from a local PC
1. Unpack the server.
2. Connect the power cable.
3. Switch on the server.
4. Using an Ethernet crossover cable, connect the local PC to the LAN1 (eth0) Ethernet
interface of the server.
Note 1:
If the PC Ethernet port is "autosensing", an Ethernet straight cable can also be used.
Note 2:
Both Compact and Premium edition platforms have three Ethernet interfaces. Looking at the back
panel, the LAN1 Ethernet port (eth0) is the left-most Ethernet port.
2-2