Removing The Main Electronic Control - KitchenAid KDRP487MSS Technical Education

REMOVING THE MAIN ELECTRONIC CONTROL

WARNING
Electrical Shock Hazard
Disconnect power before
servicing.
Replace all parts and panels
before operating.
Failure to do so can result in
death or electrical shock.
Shut off gas supply line valve
before servicing.
Check all gas line connections
and replace all parts and panels
before operating.
Failure to do so can result in
explosion, fire or other injury.
1. Turn off gas supply and disconnect power
to the range.
2. Remove the two oven doors (see page
4-26 for the procedure).
3. Remove the two screws from the left and
right front side panel trim pieces, then pull
the trim forward, and remove it.
Screw (1 of 2)
Left Side Panel Trim
Fire Hazard
Screw (1 of 2)
Right Side Panel Trim
4. Remove the three screws from each end
of the bottom trim and remove the trim.
3 Bottom Trim Screws
5. Remove the two screws from the front of
the main electronic control drawer, lo-
cated below the left side of the unit, and
pull the drawer out.
Main Electronic Control
Pull Drawer Forward
4-12
Drawer Screws