Removing A Convection Bake Element & Fan Motor Assembly - KitchenAid KDRP487MSS Technical Education

REMOVING A CONVECTION BAKE ELEMENT &
WARNING
Electrical Shock Hazard
Disconnect power before
servicing.
Replace all parts and panels
before operating.
Failure to do so can result in
death or electrical shock.
Shut off gas supply line valve
before servicing.
Check all gas line connections
and replace all parts and panels
before operating.
Failure to do so can result in
explosion, fire or other injury.
1. Turn off gas supply and disconnect power
to the range.
2. Remove the oven door from the range
(see page 4-26 for the procedure).
3. Remove the racks from inside the oven.
4. Remove the three screws from the con-
vection cover and remove the cover from
the rear of the oven liner. Note the location
of the notch in the cover. Be sure to
position the cover with the notch as shown
when you reinstall it.
Screw 1 of 3
Convection Cover
FAN MOTOR ASSEMBLY
Fire Hazard
Notch
5. To remove a convection bake element:
a) Remove the two screws from the con-
vection bake element.
b) Pull it forward so you can access the
terminals.
c) Disconnect the wires from the element
terminals.
Screw
Element Terminals
4-18
Convection Bake Element
Screw