Electronic Control Pads; Oven Displays; Start; Off - KitchenAid YKERI201 Use & Care Manual

Electronic Control Pads

When pressing any control pad function on the Electronic Oven
Control, use the pad of your finger to press the desired function.
Hold down the pad for a few seconds, or until the desired
function appears in the display.
When entering multiple functions within one setting, pause briefly
between each control pad command. If a command pad is
pressed several times repeatedly, the pad may briefly stop
working. Wait a few seconds, and the pad should function again
as normal.

Oven Displays

Style 1 Electronic Oven Control
When the oven is in use, this display shows the oven
temperature, heat source(s) and start time. During Timed
Cooking, this display also shows a timed countdown and the
stop time (if entered).
If "Err" appears on the display, an invalid pad was pressed.
Press OFF and retry your entry. When the oven is not in use, this
display is blank.
Style 2 and 3 Electronic Oven Controls
When the oven is in use, this display shows the oven temperature
and heat source(s). During Timed Cooking, this display also
shows a vertical bar and minute time countdown and the stop
time (if entered).
If "Err" appears on the display, an invalid pad was pressed.
Press OFF and retry your entry. When the oven is not in use, only
the time of day is shown on the display.
The START pad begins any oven function except the Timer,
Control Lock and Sabbath Mode. If not pressed within 5 seconds
after pressing a pad, "START?" will appear on the oven display as
a reminder. If not pressed within 4 minutes after pressing a pad,
the oven display will return to inactive mode (blank) and the
programmed function will be canceled.
The OFF pad stops any oven function except for the Clock, Timer
and Control Lock.

Clock/Timer Display

This is a 12-hour clock that does not show a.m. or p.m.
1. Press CLOCK SET/START.
2. Press number pads to set time of day.
3. Press CLOCK SET/START.
12

Start

Off

Options Selection Pad

The OPTIONS selection pad allows you to access 10 hidden
functions within the Electronic Oven Control. These hidden
functions allow you to change the oven temperature between
Fahrenheit and Celsius, turn the audible signals and prompts on
and off and adjust the oven calibration. The Sabbath Mode is
also set using the OPTIONS selection pad.
To Use: Press OPTIONS. The oven display will scroll through the
various options, starting at 1 and ending in 0. You can also press
the OPTIONS selection pad and number pad to quickly access
the desired hidden function.
OPTIONS
1 Fahrenheit and Celsius conversion
2 Sound On/Off
3 Sound High/Low
4 End Beep On/Off
5 Dehydration
6 Oven temperature calibration
7 Sabbath Mode
Tones are audible signals, indicating the following:
Style 1 Electronic Oven Control
One beep
Function has been entered
Three beeps
Invalid pad press
Event Timer Tones
Three chimes occur when the timer reaches zero. This can be
when using the timer for functions other than cooking.
Event Complete Tones
Three beeps indicate the end of a cooking cycle. Press
OPTIONS, and then 4 to turn ON. Press OPTIONS, and then 4 to
turn OFF.
Event Ready Tone
One chime indicates a preheat cycle has been completed.
All Tones
All tones are preset ON, but can be turned OFF. To turn tones ON,
press the options key, then press keypad 2. To turn tones OFF,
press the options key again, and then press keypad 2.
Tone Volume
The volume is preset at high, but can be changed to low.
To Change: Press OPTIONS, and then 3 to lower the volume.
Press options 3 to raise the volume of the tones.
End Beep
To Turn On/Off: Press OPTIONS 4 to turn OFF. Press OPTIONS 4
again to turn ON.
HIDDEN FUNCTION

Tones