KitchenAid KDRP487MSS Technical Education page 24

b) Pull the round rubber shields off the
eight gas valve shafts.
Rubber Shield
c) Disconnect the ignition switch assem-
bly wire connector from the main har-
ness.
d) Pull each of the ignition switches off the
shafts of the gas valves. NOTE: The
ignition switches are replaced as an
assembly.
Ignition Switch Wire
Pull Ignition Switch Off Shaft
6. To remove a gas valve:
a) Remove the control panel from the unit
(see step 3 on page 4-4 for the proce-
dure).
b) Remove the ignition switch from the
valve under test (see step 5 on page
4-5 for the procedure).
c) Remove the gas line from the valve.
d) Using a 1/4" open-end wrench, remove
the screw and rubber washer from the
gas valve.
e) Pull the gas valve off the manifold.
REASSEMBLY NOTES:
1. When installing a new gas valve, make
sure that the rubber washers are in place
on the valve and the screw.
2. Do not overtighten the gas valve screw
when installing it on the manifold.
Rubber Washers
4-6
Gas Line
Gas Valve
Manifold Screw &
Rubber Washer