REMOVING A HALOGEN LAMP ASSEMBLY
WARNING
Electrical Shock Hazard
Disconnect power before
servicing.
Replace all parts and panels
before operating.
Failure to do so can result in
death or electrical shock.
Shut off gas supply line valve
before servicing.
Check all gas line connections
and replace all parts and panels
before operating.
Failure to do so can result in
explosion, fire or other injury.
1.
Turn off gas supply and disconnect power
to the range.
2.
Remove the racks from inside the oven.
3.
Remove the lens from the halogen lamp
socket by lifting the end by the mounting
screw and unsnapping it.
4.
Remove the screw from the halogen lamp
assembly.
Lift Lens Here
Halogen Lamp
Mounting Screw
Fire Hazard
Assembly
5.
Pull the halogen bulb out of the socket.
Socket Assembly
6.
Pull the halogen socket assembly out of
the oven liner and cut the wires near the
socket terminals.
7.
Cut the new halogen lamp socket wires to
the proper length.
8.
Remove 3/8" of insulation from the cut
wires on the wire harness and the halogen
lamp socket. Splice the halogen lamp
socket wires to the harness wires, and
twist two wire nuts over the bare wire
ends.
4-14
Halogen Bulb
Cut Wires Here