Inspection - Suzuki RM-Z450 Owner's Service Manual

15-4 FRONT AND REAR WHEELS

INSPECTION

SPACER AND DUST SEAL
• Inspect the right and left dust seals 1 and wheel spacers 2
for wear and cracks.
• If any defects are found, replace the spacer together with the
dust seal.
NOTE:
Apply grease to the spacer and dust seal before reassembling.
FRONT AXLE
• Support the axle shaft with the V-blocks and measure the axle
shaft runout.
• If the runout exceeds the limit, replace the axle shaft with a
new one.
! Front axle runout
Service Limit: 0.25 mm (0.010 in)
" 09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
WHEEL RIM
• Measure the wheel rim runout with the dial gauge.
• If the runout exceeds the limit, replace the bearings or wheel.
! Service Limit: 2.0 mm (0.08 in) ... axial and radial
" 09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand