Suzuki RM-Z450 Owner's Service Manual page 96

• Tighten the connector clamp bolt K temporarily.
NOTE:
When install the connector clamp, fit the convex part of the con-
nector clamp onto the concave part of muffler.
• Check the clearance between exhaust pipe and radiator hose.
• Be sure to tighten the bolts and nuts in the following order.
1)Exhaust pipe nuts J
2)Muffler mounting front bolt F
3)Muffler mounting rear bolt G
4)Connector clamp bolt K
$ Exhaust pipe nut: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
Muffler mounting bolt (Front ): 43 N·m (4.3 kgf-m, 31.0 lb-ft)
Muffler mounting bolt (Rear): 23 N·m (2.3 kgf-m, 16.5 lb-ft)
Connector clamp bolt: 21 N·m (2.1 kgf-m, 15.0 lb-ft)
INSPECTION AFTER INSTALLATION
• Engine oil level (!2-11)
• Engine coolant level and leakage (!2-14, -15)
• Fuel leakage (!2-20)
• Exhaust gas leakage
• Throttle cable play (!2-17)
• Clutch cable play (!2-16)
• Drive chain slack (!2-27)
• Brake pedal height (!2-32)
• Wire, cable and hose routing (!19-18 to -22)
ENGINE REMOVAL AND INSTALLATION 5-9