Wheels And Tires - Ezgo MPT 800 Owner's Manual And Service Manual

O P E R A T I O N A N D S E R V I C E I N F O R M A T I O N
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
!
from a jack:
Be sure the vehicle is on a firm and level surface.
Never get under a vehicle while it is supported by
a jack.
Use jack stands and test the stability of the vehi-
cle on the stands.
Always place chocks in front and behind the
wheels not being raised.
Use extreme care since the vehicle is extremely
unstable during the lifting process.
When lifting vehicle, position jacks and
jack stands at the areas indicated only.
To raise the entire vehicle, install chocks in front and
behind each front wheel (Ref. Fig. 16 on page 10). Cen-
ter the jack under the rear frame crossmember. Raise
the vehicle enough to place a jack stand under the outer
ends of the rear axle.
Lower the jack and test the stability of the vehicle on the
two jack stands.
Place the jack at the center of the front axle. Raise the
vehicle enough to place jack stands under the frame
crossmember as indicated.
Lower the jack and test the stability of the vehicle on all
four jack stands.
If only the front or rear of the vehicle is to be raised, place
the chocks in front and behind each wheel not being
raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.

WHEELS AND TIRES

Tire Repair
Tool List
Lug wrench, 3/4" ......................................................... 1
Impact socket, 3/4", 1/2" drive ..................................... 1
Impact wrench, 1/2" drive ............................................ 1
Torque wrench, 1/2" drive ........................................... 1
!
inflation pressure rating on tire sidewall.
Page 10
To reduce the possibility
!
of severe injury or death
from a vehicle falling
Qty. Required
A ti re e xp l o si o n c a n
!
cause severe injury or
d e a t h . N e v e r e x c e e d
Owner's Manual and Service Guide
Center of
Front Axle
View from Underside of Vehicle
Ref Liv 1
Fig. 16 Lifting the Vehicle
To reduce the possibility of tire explosion, pres-
surize tire with small amount of air applied inter-
mittently to seat beads. Due to the low volume of
the small tires, overinflation can occur in sec-
onds. Never exceed the tire manufacturer's rec-
ommendation when seating a bead. Protect face
and eyes from escaping air when removing valve
core.
To reduce the possibility of severe injury caused
by a broken socket when removing wheels, use
only sockets designed for impact wrench use.
Use caution when inflating tires. Overinflation
could cause the tire to separate from the wheel or
cause the tire to explode, either of which could
cause severe injury.
Use caution when inflating tires. Due to the low volume of
the small tires, overinflation can occur in seconds. Over-
inflation could cause the tire to separate from the wheel
or cause the tire to explode.
Tire inflation should be determined by the condition of
the terrain. See GENERAL SPECIFICATIONS section
for recommended tire inflation pressure. For outdoor
applications with major use on grassy areas, the follow-
Flat Portion
of Frame
Outside End
of Rear Axle