Wheels And Tires; Tire Repair - Ezgo REFRESHER 1200 Owner's Manual

Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
If only the front or rear of the vehicle is to be raised, place
the chocks in front and behind each wheel not being
raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
Centro del
eje delantero
Vista desde debajo del vehículo
Ref Liv 1
Fig. 14 Lifting the Vehicle

WHEELS AND TIRES

Tire Repair

Tool List
Lug wrench, 3/4" ......................................................... 1
Impact socket, 3/4", 1/2" drive..................................... 1
Impact wrench, 1/2" drive............................................ 1
Torque wrench, 1/2" drive ........................................... 1
A tire explosion can cause severe injury or
death. Never exceed inflation pressure rat-
ing on tire sidewall.
To reduce the possibility of tire explo-
sion, pressurize tire with small amount
OPERATION AND SERVICE INFORMATION
Do not use low inflation pressure tires on
Porción plana
del bastidor
any E-Z-GO vehicle. Do not use any tire
which has a recommended inflation pres-
sure less than the inflation pressure recom-
mended in Owner's Manual.
Use caution when inflating tires. Due to the low volume of
the small tires, overinflation can occur in seconds. Over-
inflation could cause the tire to separate from the wheel
Borde exterior
or cause the tire to explode.
del eje trasero
Tire inflation should be determined by the condition of the
terrain. See GENERAL SPECIFICATIONS section for
recommended tire inflation pressure. For outdoor appli-
cations with major use on grassy areas, the following
should be considered. On hard turf, it is desirable to have
a slightly higher inflation pressure. On very soft turf, a
lower pressure reduces the possibility of tires cutting into
the turf. For vehicles being used on paved or hard sur-
faces, tire inflation pressure should be in the higher
Qty. Required
allowable range, but under no condition should inflation
pressure be higher than recommended on tire sidewall.
All four tires should have the same pressure for opti-
mum handling characteristics. Be sure to install the valve
dust cap after checking or inflating.
The vehicle is fitted with low pressure tubeless tires
mounted on one piece rims; therefore, the most cost
effective way to repair a puncture in the tread is to use a
commercial tire plug.
Tire plug tools and plugs are available at most automotive parts
outlets and have the advantage of not requiring the tire be
Owner's Manual and Service Guide
of air applied intermittently to seat
beads. Due to the low volume of the
small tires, overinflation can occur in
seconds. Never exceed the tire manufac-
turer's recommendation when seating a
bead. Protect face and eyes from escap-
ing air when removing valve core.
To reduce the possibility of severe injury
caused by a broken socket when remov-
ing wheels, use only sockets designed
for impact wrench use.
Use caution when inflating tires. Overin-
flation could cause the tire to separate
from the wheel or cause the tire to
explode, either of which could cause
severe injury.
Page 13