Service And Maintenance; Serial Number Label Location - Ezgo MPT 800 Owner's Manual And Service Manual

Gasoline powered utility vehicles
Table of Contents

Advertisement

Available languages

Available languages

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
If the vehicle is to be transported at highway speeds, the
sun top must be removed and the seat bottom secured.
When transporting vehicle below highway speeds, check
for tightness of hardware and cracks in sun top at mount-
ing points. Always remove windshield when transporting.
Always check that the vehicle and contents are ade-
quately secured before transporting. The rated capacity
of the trailer or truck must exceed the weight of the vehi-
cle (see GENERAL SPECIFICATIONS for vehicle
weight) and load. Lock the park brake and secure the
vehicle using ratchet tie downs.

SERVICE AND MAINTENANCE

!
techniques:
Do not attempt any type of servicing operations
before reading and understanding all notes, cau-
tions and warnings in this manual.
Any servicing requiring adjustments to be made
to the powertrain while the engine is running
must be made with both drive wheels raised and
vehicle properly supported on jack stands.
To reduce the possibility of engine damage, never
operate vehicle at full throttle for more than 4 - 5
seconds while vehicle is in a 'no load' condition.
Wear eye protection when working on
the vehicle. Use extra care when work-
ing around batteries, or using sol-
vents or compressed air.
To reduce the possibility of causing an electrical
arc, which could result in a battery explosion, turn
off all electrical loads from the battery before
removing battery wires.
ing out' a battery, which could result in an explo-
sion.
Reduce the possibility of accidental starting by
removing and grounding spark plug wires and
disconnecting battery at negative terminal before
servicing.
The electrolyte in a battery is an acid solution
which can cause severe burns to the skin and
eyes. Treat all electrolyte spills to the body and
To reduce the possibility
!
of severe injury or death
from improper servicing
Wrap wrenches with vinyl
tape to reduce the possibility
of a dropped wrench 'short-
Owner's Manual and Service Guide
O P E R A T I O N A N D S E R V I C E I N F O R M A T I O N
eyes with extended flushing with clear water.
Contact a physician immediately.
Any electrolyte spills should be neutralized with a
solution of 2 teaspoons (10 ml) sodium bicarbon-
ate (baking soda) dissolved in 1 quart (1 liters) of
water and flushed with water.
Aerosol containers of battery terminal protectant
must be used with extreme care. Insulate metal
container to reduce the possibility of can contact-
ing battery terminals which could result in an
explosion.
It is in the best interest of both vehicle owner and service
technician, to carefully follow the procedures recom-
mended in this manual. Preventative maintenance,
applied at recommended intervals, is the best guarantee
for keeping the vehicle both dependable and economical.
This vehicle will give years of satisfactory service, provid-
ing it receives regular maintenance. Refer to the Periodic
Service Schedule for appropriate service intervals (Ref.
Fig. 21 on page 14). Refer to Lubrication Points for
appropriate lubrication locations (Ref. Fig. 40 on page
22).
quently on vehicles used under severe driving conditions such
as extreme temperatures, extreme dust/debris conditions, fre-
quent use with maximum load.
To access powertrain for routine maintenance, lift or
remove seat. For major repair, refer to appropriate Tech-
nician's Repair and Service Manual.
Some service procedures may require the vehicle to be
lifted. Refer to LIFTING THE VEHICLE for proper lifting
procedure and safety information.

SERIAL NUMBER LABEL LOCATION

Two serial number and manufacture date code label are
on the vehicle. One is placed on the body below the
front, driver side of the seat. The other is located on the
chassis under the seat.
Design changes take place on an ongoing basis. In order
to obtain correct components for the vehicle, the manu-
facture date code, serial number and vehicle model must
be provided when ordering service parts.
To prolong vehicle life, some mainte-
nance items must be serviced more fre-
Page 13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Industrial 800Industrial 1200

Table of Contents